howto:bootes:bootes_ir
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
howto:bootes:bootes_ir [2008/09/06 20:54] – external edit 127.0.0.1 | howto:bootes:bootes_ir [Unknown date] (current) – external edit (Unknown date) 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Dome opening and closing ====== | ||
+ | |||
+ | You cannot open dome manually using buttons in copula if // | ||
+ | |||
+ | If you left dome in remote mode, and you try to open it, it will close as soon as you release opening button. That is a new security feature, which makes sure that dome is closed if it should be closed. Removing it will affect our other setups, and as there is a solution for manual control, I am not inflicting towards removing it. You can open dome from // | ||
+ | |||
====== Telescope referencing ====== | ====== Telescope referencing ====== | ||
Line 25: | Line 31: | ||
====== Setting dome parking position ====== | ====== Setting dome parking position ====== | ||
- | Dome park position can be set only locally on dome control box. The box has eight small buttons and five line of LCD display. First, switch box to **remote** mode by turning key clokwise. Then press simultaneusly left and right top buttons. System will enter **technical** mode, where you can change various parameters. Using right and left top buttons, move to screen | + | Dome park position can be set only locally on dome control box. The box has eight small buttons and five line of LCD display. First, switch box to **remote** mode by turning key clokwise. Then press simultaneusly left and right top buttons. System will enter **technical** mode, where you can change various parameters. Using right and left top buttons, move to screen |
- | To save park position, so it will be remembered after power cycling of the dome control box, go to screen 18 and set **Save params** to 1. | + | To save park position, so it will be remembered after power cycling of the dome control box, go to screen 18 and set **Save params** to 1. Move line down/up, you will get **Written 83.." message on screen, which will disappear after a while. |
howto/bootes/bootes_ir.1220727282.txt.gz · Last modified: 2008/11/12 00:00 (external edit)